|
|
1.1 ! root 1: .\" Copyright (c) 1983 Regents of the University of California. ! 2: .\" All rights reserved. The Berkeley software License Agreement ! 3: .\" specifies the terms and conditions for redistribution. ! 4: .\" ! 5: .\" @(#)pcl.4 6.2 (Berkeley) 5/21/86 ! 6: .\" ! 7: .TH PCL 4 "May 21, 1986" ! 8: .UC 5 ! 9: .SH NAME ! 10: pcl \- DEC CSS PCL-11 B Network Interface ! 11: .SH SYNOPSIS ! 12: .B "device pcl0 at uba? csr 164200 vector pclxint pclrint" ! 13: .SH DESCRIPTION ! 14: The ! 15: .I pcl ! 16: device provides an IP-only interface to the DEC CSS PCL-11 ! 17: time division multiplexed network bus. ! 18: The controller itself is not accessible to users. ! 19: .PP ! 20: The hosts's address is specified with the SIOCSIFADDR ioctl. ! 21: The interface will not transmit or receive any data before ! 22: its address is defined. ! 23: .PP ! 24: As the PCL-11 hardware is only capable of having 15 interfaces per network, ! 25: a single-byte host-on-network number is used, with range [1..15] to match ! 26: the TDM bus addresses of the interfaces. ! 27: .PP ! 28: The interface currently only supports the Internet protocol family ! 29: and only provides ``natural'' (header) encapsulation. ! 30: .SH DIAGNOSTICS ! 31: .BR "pcl%d: can't init" . ! 32: Insufficient UNIBUS resources existed to initialize the device. ! 33: This is likely to occur when the device is run on a buffered ! 34: data path on an 11/750 and other network interfaces are also ! 35: configured to use buffered data paths, or when it is configured ! 36: to use buffered data paths on an 11/730 (which has none). ! 37: .PP ! 38: .BR "pcl%d: can't handle af%d" . ! 39: The interface was handed a message with addresses formatted in an ! 40: unsuitable address family; the packet was dropped. ! 41: .PP ! 42: .BR "pcl%d: stray xmit interrupt" . ! 43: An interrupt occurred when no output had previously been started. ! 44: .PP ! 45: .BR "pcl%d: master" . ! 46: The TDM bus had no station providing ``bus master'' timing signals, ! 47: so this interface has assumed the ``master'' role. This message should ! 48: only appear at most once per UNIBUS INIT on a single system. ! 49: Unless there is a hardware failure, only one station may be master at at time. ! 50: .PP ! 51: .BR "pcl%d: send error, tcr=%b, tsr=%b" . ! 52: The device indicated a problem sending data on output. ! 53: If a ``receiver offline'' error is detected, it is not normally logged ! 54: unless the option PCL_TESTING has been selected, as this causes a lot ! 55: of console chatter when sending to a down machine. However, this option ! 56: is quite useful when debugging problems with the PCL interfaces. ! 57: .PP ! 58: .BR "pcl%d: rcv error, rcr=%b rsr=%b" . ! 59: The device indicated a problem receiving data on input. ! 60: .PP ! 61: .BR "pcl%d: bad len=%d" . ! 62: An input operation resulted in a data transfer of less than ! 63: 0 or more than 1008 bytes of ! 64: data into memory (according to the word count register). ! 65: This should never happen as the maximum size of a PCL message ! 66: has been agreed upon to be 1008 bytes (same as ArpaNet message). ! 67: .SH "SEE ALSO" ! 68: intro(4N), inet(4F)
This archive runs on limited infrastructure. Preserving old code on modern bandwidth. Automated agents are requested to crawl responsibly.